User`s guide

Preparing for Imaging 4
Agilent 5500 SPM User’s Guide 71
Figure 45 Placing scanner assembly into microscope
3 Finger-tighten the knob on the right side of the microscope to lock
the scanner in position.
4 Attach the high voltage (red) and low voltage (blue) cables on either
side of the scanner to the sockets on the microscope base. The cables
are color coded to avoid confusion. If you are using a closed-loop
scanner, connect its third cable to the C/L socket on the rear of the
Head Electronics Box.
CAUTION
To remove the scanner, turn off all power THEN disconnect cables.