Technical data

Chapter 9 111

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Each of these commands can be used to change just one parameter within an analyzer sequence.

Acquisition Parameters (Parameter-Specific Commands)

This section describes the 18 parameters which configure the test set for an acquisition.

An additional 5 parameters are used to define analysis intervals within an acquisition, as described in

“Analysis Step Parameters (Parameter-Specific Commands)” on page 126.

1: Acq Number

As acquisitions are simply numbered sequentially within the sequence, there is no parameter-specific

command for setting the number of an acquisition. However, in the commands given below, it is

necessary to identify the acquisition by number in the ACQuire value.

2: Radio Standard

For a description of this parameter, see “2: Radio Standard” on page 23. The parameter-specific

commands are described below.

SCPI Command

To set the radio standard as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:STANdard

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:RADio:

STANdard?

To set the radio standard as an array:

[:SENSe]:LSEQuencer:LIST:SETup:RADio:STANdard

<enum>,<enum>,<enum>,…

[:SENSe]:LSEQuencer:LIST:SETup:RADio:STANdard?

The array form of the command is used to make a different setting for each

acquisition in the sequence (the number of array values must match the

number of acquisitions; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:SET:RAD:STAN CDMA2K

:LSEQ:ACQ2:SET:RAD:STAN?

:LSEQ:LIST:SET:RAD:STAN NONE,WCDMA,CDMA2K,CDMA1XEV

:LSEQ:LIST:SET:RAD:STAN?