Technical data

122 Chapter 9
Sequence Setup Commands
Programming Analyzer Sequences (Parameter-Specific Commands)
Sequence Setup Commands
12: Input Trigger Level
For a description of this parameter, see “12: Input Trigger Level” on page 28. The parameter-specific
commands are described below.
13: Input Trigger Delay
For a description of this parameter, see “13: Input Trigger Delay” on page 28. The parameter-specific
commands are described below.
SCPI Command
To set the input trigger level as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TRIGger
[:INPut]:LEVel <amp>
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TRIGger
[:INPut]:LEVel?
To set the input trigger level as an array:
[:SENSe]:LSEQuencer:LIST:SETup:TRIGger[:INPut]:
LEVel <amp>,<amp>,<amp>,…
[:SENSe]:LSEQuencer:LIST:SETup:TRIGger[:INPut]:LEVel?
The array form of the command is used to make a different setting for each
acquisition in the sequence (the number of array values must match the
number of acquisitions; otherwise a "settings conflict" error will occur).
SCPI Examples :LSEQ:ACQ2:SET:TRIG:INP:LEV -10dBm
:LSEQ:ACQ2:SET:TRIG:INP:LEV?
:LSEQ:LIST:SET:TRIG:INP:LEV 0,-10dBm,-20dBm
:LSEQ:LIST:SET:TRIG:INP:LEV?
SCPI Command
To set the input trigger delay as an individual value:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TRIGger
[:INPut]:DELay <time>
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TRIGger
[:INPut]:DELay?
To set the input trigger delay as an array:
[:SENSe]:LSEQuencer:LIST:SETup:TRIGger[:INPut]:DELay
<time>,<time>,<time>,…
[:SENSe]:LSEQuencer:LIST:SETup:TRIGger[:INPut]:DELay?
SCPI Examples :LSEQ:ACQ2:SET:TRIG:INP:DEL -200us
:LSEQ:ACQ2:SET:TRIG:INP:DEL?
:LSEQ:LIST:SET:TRIG:INP:DEL 0,-200us,-100us
:LSEQ:LIST:SET:TRIG:INP:DEL?