Technical data

134 Chapter 9
Sequence Setup Commands
Programming Source Sequences (Parameter-Specific Commands)
Sequence Setup Commands
7: Power
For a description of this parameter, see “7: Power” on page 40. The parameter-specific commands are
described below.
8: Waveform
For a description of this parameter, see “8: Waveform” on page 40. The parameter-specific commands
are described below.
9: Step Duration
For a description of this parameter, see “9: Step Duration” on page 40. The parameter-specific
commands are described below.
10: Time / Count
For a description of this parameter, see “10: Time / Count” on page 41. The parameter-specific
commands are described below.
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:AMPLitude <double>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:AMPLitude?
Example: :SOUR:LIST:STEP2:SET:AMPL –50dBm
:SOUR:LIST:STEP2:SET:AMPL?
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:WAVeform <string>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:WAVeform?
Example: :SOUR:LIST:STEP2:SET:WAV “CW”
:SOUR:LIST:STEP2:SET:WAV?
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TYPE
TIME|COUNt|CONTinuous
:SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TYPE?
Example: :SOUR:LIST:STEP2:SET:DUR:TYPE TIME
:SOUR:LIST:STEP2:SET:DUR:TYPE?
Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt
<double>
:SOURce:LIST:STEP[1]|2|3…1000:SETup:DURation:TCOunt?
Example: :SOUR:LIST:STEP2:SET:DUR:TCO 1s
:SOUR:LIST:STEP2:SET:DUR:TCO 10
:SOUR:LIST:STEP2:SET:DUR:TCO?