Technical data

Chapter 11 165
Example Test Scenarios
Verification Example
Example Test Scenarios
Setting Up The Sequence
With Agilent I/O Libraries running, and “EXT1” established as the VISA alias for the test set, we launch
the Sequence Studio application, and click on the “Connect” icon to connect Sequence Studio to the test
set. The “Not Connected” message at the bottom of the window is replaced by “Connected to
E6640A...”, and the “Connect” icon becomes a “Disconnect” icon.
Figure 11-18. Connecting Sequence Studio to the Test Set
Connecting to the EXM causes the test set’s global instrument settings to be uploaded automatically to
Sequence Studio; we will modify these settings as needed for the purposes of the ILPC test. (For
example, we will set the IF BW settings on all of the “Basic” measurement tabs to 3.84 MHz.) The title
of the “Instrument Settings” tab is shown in red and marked with an asterisk until we have actually
transferred the changes in the settings to the test set by clicking the
Download to Instrument button).
Figure 11-19. Instrument Settings for Sequence Studio