Technical data

174 Chapter 12
Basic Measurements Programming Commands
Basic Transmit Power
Basic Measurements Programming
Commands
Basic transmit power results
The parameters and default setting for this command are detailed in the following table. The first SCPI
parameter is Index 0.
Index Result Parameter
0 Overall Pass/Fail result - shows the mask test result (0.0 = pass, 1.0 = fail, -1.0
not tested)
1 Upper Limit Pass/Fail Result shows the upper limit test result (0.0 = pass, 1.0 =
fail, -1.0 not tested)
2 Lower Limit Pass/Fail Result shows the upper limit test result (0.0 = pass, 1.0 =
fail, -1.0 not tested)
3 Basic Tx Power is the accumulated power over the measurement interval set for
this Analysis Interval. It is a floating point number.