Technical data

182 Chapter 13

GSM/EDGE Programming Commands

GSM/EDGE Programming

GSM/EDGE Programming Commands

GSM/EDGE Programming

GSM/EDGE measurements can be made in the List Sequencer when you have the GSM/EDGE

measurement application licensed in the test set. The SCPI commands for setting each of the

GSM/EDGE measurements from inside the Sequence Analyzer mode are listed in this chapter. Changes

to these parameters made from within the List Sequencer result in changes to the equivalent parameters

in the measurement mode.

The GSM/EDGE measurements that are supported in the List Sequencer are:

• GMSK Phase and Frequency Error (PFER)

• EDGE Power vs. Time (PvT)

• GSM Loopback BER

• EDGE Power vs. Time (PvT)

• EDGE EVM

• EDGE Output RF Spectrum (ORFS)