Technical data

Chapter 13 187
GSM/EDGE Programming Commands
EDGE Power vs. Time (PvT)
GSM/EDGE Programming Commands
EDGE Power vs. Time (PvT)
This section provides the remote control SCPI commands for the EDGE Power vs. Time (PvT)
measurement from within the List Sequencer. This measurement is available only if you have the
GSM/EDGE measurement application licensed on the test set.
For more detailed information about the PvT measurement, refer to the online help associated with the
GSM/EDGE measurement application, which is also available in PDF format (“User’s and
Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series GSM/EDGE measurement application,
which is available on the Agilent website, www.agilent.com/find/mxa.
EDGE Power vs. Time (PvT) measurement SCPI commands
There is a set of SCPI commands available to program the EDGE PvT measurement when it is used in
the GSM/EDGE mode. To set up the GSM measurements from within the Sequence Analyzer mode you
need to prefix the SCPI commands with LSEQuencer:EDGE. For example, the [:SENSe]:EPVTime
part of the EDGE PvT SCPI commands are replaced with [:SENSe]:LSEQuencer:EDGE:EPVTime.
The following commands are used to set up the EDGE PvT measurement.
[:SENSe]:]LSEQuencer:EDGE:EPVTime:BANDwidth[:RESolution] <bandwidth>
[:SENSe]:LSEQuencer:EDGE:EPVTime:BANDwidth[:RESolution]:TYPE
FLATtop|GAUSsian
[:SENSe]:LSEQuencer:EDGE:EPVTime:BSYNc:SOURce
TSEQuence|RFBurst|NONE|RFAMplitude
:CALCulate:LSEQuencer:EDGE:EPVTime:LIMit:TEST:STATe OFF|ON|0|1
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:SELect STANdard|CUSTom
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:RPOWer:TYPE UPARt|MAMBle|ESTimated
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:RPOWer <ampl>
[:SENSe]:LSEQuencer:EDGE:EPVTime:BSYNC:SLENgth EVEN|INTeger
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:LOWer:ABSolute <real>,...
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:LOWer:POINts?
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:LOWer:RELative <rel_ampl>
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:LOWer:TIMe <seconds>,...
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:UPPer:ABSolute <real>,...
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:UPPer:POINts?
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:UPPer:RELative <rel_ampl>,...
[:SENSe]:LSEQuencer:EDGE:EPVTime:MASK:LIST:UPPer:TIMe <seconds>,...