Technical data

234 Chapter 15
cdma2000 Programming Commands
Modulation Accuracy
cdma2000 Programming Commands
Modulation Accuracy
This section provides the remote control SCPI commands for the cdma2000 Modulation Accuracy
measurement from within the List Sequencer. This measurement is available only if you have the
cdma2000 measurement application licensed on the test set.
For more detailed information about the cdma2000 Modulation Accuracy measurement, refer to the
online help associated with the cdma2000 measurement application, which is also available in PDF
format (“User’s and Programmer’s Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series cdma2000 measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
Modulation Accuracy measurement SCPI commands
There is a set of SCPI commands available to program the cdma2000 modulation accuracy measurement
when it is used in the cdma2000 mode. To set up the cdma2000 measurements from within the Sequence
Analyzer mode you need to prefix the SCPI commands with LSEQuencerC2K. For example, the
[:SENSe]:RHO part of the modulation accuracy SCPI commands are replaced with:
[:SENSe]:LSEQuencer:C2K:RHO
The following commands are used to set up the modulation accuracy measurement.
:CALCulate:LSEQuencer:C2K:RHO:LIMit:RMS
:CALCulate:LSEQuencer:C2K:RHO:LIMit:PEAK
:CALCulate:LSEQuencer:C2K:RHO:LIMit:RHO
:CALCulate:LSEQuencer:C2K:RHO:LIMit:CDERror
:CALCulate:LSEQuencer:C2K:RHO:LIMit:TIMing
:CALCulate:LSEQuencer:C2K:RHO:LIMit:PHASe
:CALCulate:LSEQuencer:C2K:RHO:PNOFfset
[:SENSe]:LSEQuencer:C2K:RHO:SYNC[:BTS]
[:SENSe]:LSEQuencer:C2K:RHO:SYNC:LCMask
[:SENSe]:LSEQuencer:C2K:RHO:RCONfig
[:SENSe]:LSEQuencer:C2K:RHO:SPECtrum
:CALCulate:LSEQuencer:C2K:RHO:IQOFfset:INCLude
:CALCulate:LSEQuencer:C2K:RHO:ASET:THReshold
[:SENSe]:LSEQuencer:C2K:RHO:ALPHa
[:SENSe]:LSEQuencer:C2K:RHO:CRATe
[:SENSe]:LSEQuencer:C2K:RHO:MCEStimator