Technical data

328 Chapter 20
Bluetooth Programming Commands
EDR In-band Spurious Emission
Bluetooth Programming Commands
EDR In-band Spurious Emission
This section provides the remote control SCPI commands for the Bluetooth EDR In-band Spurious
Emission measurement from within the List Sequencer. This measurement is available only if you have
the Bluetooth measurement application licensed on the test set.
For more detailed information about the BER measurement, refer to the online help associated with the
Bluetooth measurement application, which is also available in PDF format (“User’s and Programmer’s
Reference”) on the Agilent website, www.agilent.com/find/e6640a.
You can also refer to the measurement guide for the X-series Bluetooth measurement application, which
is available on the Agilent website, www.agilent.com/find/mxa.
EDR In-band Spurious Emission measurement SCPI commands
There is a set of SCPI commands available to program the Bluetooth EDR In-band Spurious Emission
measurement when it is used in the Bluetooth mode. To set up the Bluetooth measurements from within
the Sequence Analyzer mode you need to prefix the SCPI commands with LSEQuencer:BTooth. For
example, the [:SENSe]:IBSPurious part of the EDR In-band Spurious Emission SCPI commands
are replaced with [:SENSe]:LSEQuencer:BTooth:IBSPurious.
The following commands are used to set up the EDR In-band Spurious Emission measurement.
:CALCulate:LSEQuencer:BTooth:IBSPurious:LIMit:STATe
:CALCulate:LSEQuencer:BTooth:IBSPurious:LIMit:FAR:UPPer[:DATA]
:CALCulate:LSEQuencer:BTooth:IBSPurious:LIMit:NEAR:UPPer[:DATA]
[:SENSe]:LSEQuencer:BTooth:IBSPurious:FREQuency:SPAN
EDR In-band Spurious Emission Results results
Index Result Parameter
0 Overall Pass/Fail
TxRefIndex
TxRefPower
Adj500kHzPowerUpper
Adj500kHzPowerLowerr
NumberofExceptions
1 Power Results
Returns up to 79 scalar values (comma separated) of the Tx power per channel. The number of the
meaningful results depends on the Span. And the meaningful value were placed the head of the array.