Technical data

Chapter 5 57
Mode Parameters
Mode and Measurement Parameters
Mode Parameters
GSM RF Sync Delay
RF Sync Delay setting for GSM mode. Adjusts the "T0" point that has been measured in each
measurement. This adjustment does not apply if the Burst Sync key (in each measurement's Meas Setup
menu) is set to None. For more details about the command see the GSM/EDGE online help (or in pdf
format, the User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:EDGE:SYNC:BURSt:RFAMplitude:DELay <time>
[:SENSe]:LSEQuencer:EDGE:SYNC:BURSt:RFAMplitude:DELay?
WCDMA HSDPA/HSUPA Enable
HSDPA/HSUPA Enable setting for WCDMA mode. Allows you to specify the HSDPA/HSUPA option
enable as On or Off. This selection is necessary because some of the auto detection functions which are
expecting an HSPA signal are less tolerant when the signal is noisy or distorted; it should be off when an
HSPA signal is not expected. For more details about the command see the W-CDMA online help (or in
pdf format, the User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:WCDMa:RADio:CONFigure:HSDPa[:STATe] 0|1|ON|OFF
[:SENSe]:LSEQuencer:WCDMa:RADio:CONFigure:HSDPa[:STATe]?
1xEV-DO Physical Layer SubType
Physical Layer Subtype setting for1xEV-DO mode. Allows you to select the subtype used in
measurement. For more details about the command see the 1xEV-DO online help (or in pdf format, the
User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:EVDO:RADio:PLSubtype SUB0|SUB2|SUB3
[:SENSe]:LSEQuencer:EVDO:RADio:PLSubtype?
1xEV-DO Pre-define Offset/Interval
Pre-defined Offset/Interval setting for 1xEV-DO mode. Allows you to select a desired slot (the
possibilities are Idle Slots 1 & 2, Half Slots 1 & 2, Pilot 1 & 2, MAC 1 through 4, and Full Slot). For
more details about the command see the 1xEV-DO online help (or in pdf format, the User’s and
Programmer’s Reference).
[:SENSe]:LSEQuencer:EVDO:STYPe
IS1|IS2|HS1|HS2|PIL1|PIL2|MAC1|MAC2|MAC3|MAC4|FS
[:SENSe]:LSEQuencer:EVDO:STYPe?
TD-SCDMA Analysis Timeslot
Analysis timeslot setting for TD-SCDMA mode. It specifies which sub-frames timeslot, within the
selected Sub-frame, is used for analysis and trace data measurement results. The available selections
include timeslots 0 through 6, the DwPTS and UpPTS timeslots. For more details about the command see
the TD-SCDMA online help (or in pdf format, the User’s and Programmer’s Reference).
[:SENSe]:LSEQuencer:TDSCdma:SLOT TS0|TS1|TS2|TS3|TS4|TS5|TS6|UPTS|DPTS