Technical data

76 Chapter 5
Mode Parameters
Save and Recall
Mode Parameters
Figure 5-4. Recall a Sequence
The SCPI command for this feature is
:MMEMory:LOAD:SEQuences:|SLIst|ALISt|SAAList “MySequence.txt”
This command recalls a file called MySequence.txt from the D drive in My Documents\Sequences
directory and loads it into the list sequencer for immediate use. The Sequence Analyzer mode provides
operation in SINGLE sweep mode only and therefore the sequence starts when the front panel hardkey,
Single or Restart is pressed and the appropriate trigger has been received. In remote control operation
the sequence is started when the command INITiate:IMMediate or INITiate:RESTart is
sent.
For more information about the SCPI commands refer to the Sequence Analyzer online help (or in pdf
format, the User’s and Programmer’s Reference).