Technical data

84 Chapter 6
Front Panel Sequence Setup
Front Panel List Sequencer Setup
Front Panel Sequence Setup
•Phase Discon
•Loopback BER
Step 7. In the Analysis Step Setup menu, use the Expected Power at DUT Output softkey to set the
expected power level in dBm.
To run a Sequence
Once you have set up all mode, measurement, global list sequencer, and acquisition parameters you can
start the sequence. The Sequence Analyzer mode typically operates in SINGLE sweep mode and
therefore the sequence starts when the front panel hardkey,
Single or Restart is pressed and the
appropriate trigger has been received.