Technical data

123
Two Port Insertion Loss
4 Two Port Insertion Loss
“Measuring Two Port Insertion Loss” on page 124
“Performing a Basic Two Port Insertion Loss Measurement (Normalize)” on
page 125
“Displaying Location Information Using GPS” on page 126
“Setting Average, Sweep, and Restart” on page 127
“Adding a Marker” on page 130
“Measuring Two Port Insertion Loss for Spectrum Analyzer, Channel Scanner,
1xEV-DO Analyzer, CDMA Analyzer, and Signal Generator (RF In Loss and
RF Out Loss)” on page 131
“Measuring Insertion Loss for Power Meter (Option 600 - Power Meter Only)”
on page 134
“Determining The Lowest (Worst) Insertion Loss and Its Frequency” on
page 135
“Determining the Highest (Best) Insertion Loss and Its Frequency” on page 136
“Using the Delta Marker to Measure a Difference in Insertion Loss or
Frequency” on page 136
“Activating Interference Rejection” on page 136
“Clearing Normalization” on page 137
“Setting Source Level” on page 137
“Optimizing Dynamic Range” on page 139
“Setting the Pass/Fail Limits” on page 140