Technical data

Chapter 4 129
Two Port Insertion Loss
Measuring Two Port Insertion Loss
Two Port Insertion Loss
NOTE These two steps can be performed in any order. However, if you turn averaging on
and a large number of averages has previously been set, there may be a delay before
you can change number of averages.
Setting Restart
When you have averaging turned
On and you are in Continuous Sweep mode, you
can restart the averaging by pressing the Restart menu key. The Restart key has no
effect if you are in
Single sweep mode.
NOTE Pressing the Restart key has no effect on the average count when performing Group
Average or Group Max.
To restart averaging:
Step Notes
1 [Average/Sweep]
2 [Restart] This key is unavailable or has no effect when
Sweep is set to Single. To restart a Single
Sweep measurement, press [Single].