Technical data

Chapter 5 143
Adjacent Channel Power
Using the Adjacent Channel Power Measurement
Adjacent Channel Power
Making a Basic Adjacent Channel Power Measurement
Step Notes
1. Select Adjacent Channel Power.
a.
Mode
b. [Spectrum Analyzer/Tools]
c. [Adjacent Channel Power]
2 Select the channel standard.
a. [Chan Std]
b. Select the standard using the up
and down arrow buttons.
c. [Select]
3 On [Units] select
Chan. Each time you press this softkey, the
selected option changes. (The
instructions in this manual show
selections for Channel.)
4 Setup the frequency/channel you
want to view.
a. [Freq/Chan]
b. [Channel]
c. Enter the number on the
numeric keypad.
d. [Fwd] or [Rev]
5 Connect to the base station.
6 Set the level/location.
a. [Level/Location]
b. [Autoscale]
c. [Select]
If the adjacent channel power trace is not
visible, you can change the reference
level or use Autoscale to have the test set
select a reference level for you.