Technical data

148 Chapter 5
Adjacent Channel Power
Using the Adjacent Channel Power Measurement
Adjacent Channel Power
4 Set the carrier and adjacent channel
bandwidth.
a. [Channel BW/Time]
b. [Center Chan Meas BW]
c. Enter the center channel bandwidth on
the numeric keypad.
d. [GHz] or [MHz] or [kHz] or [Hz]
e. [Center Chan Meas Time]
f. Enter the center channel measurement
time on the numeric keypad.
g. [ms]
h. [Adj Chan Meas BW]
i. Enter the adjacent channel bandwidth
on the keypad.
j. [GHz] or [MHz] or [kHz] or [Hz]
k. [Adj Chan Meas Time]
l. Enter the adjacent channel measurement
time on the keypad.
m. [ms]
5 Enable the frequency error function from
the BW/Time menu.
a. On [Freq Err] select
On. Each time you
press this menu key, the Frequency
Error state (
On or Off) changes.
b. [Back]
When Frequency Error is
switched On, the Frequency
Error result is added to the
metrics display at the bottom of
the screen.
6 Set the offset from the carrier to the first
adjacent channel.
a. [Ctr to Adj Step Size]
b. Enter the offset on the numeric keypad.
c. [GHz] or [MHz] or [kHz] or [Hz]