Technical data

190 Chapter 7
CDMA Analyzer
Optional CDMA Tx Analyzer Measurement Settings
CDMA Analyzer
Optional CDMA Tx Analyzer Measurement Settings
You can change several optional measurement parameters in the CDMA Tx
Analyzer:
• “Setting the Channel or Frequency Step” on page 190
• “Setting the PN Increment” on page 191
• “Setting the CDMA Transmitter Reference Level” on page 193
• “Setting the Active Channel Threshold Level and Auto Threshold Level” on
page 194
• “Setting Measurement Time” on page 195
• “Setting Quick Page Channel” on page 196
• “Setting Average, Sweep, and Restart” on page 197
• “Adding a Marker” on page 198
• “Setting the Pass/Fail Limits” on page 200
Setting the Channel or Frequency Step
You can set the channel or frequency step so you can quickly increment to the next
channel or frequency using the up and down arrow buttons.
Step Notes
1. [Chan Step] or [Freq
Step]
This choice depends on the [Units] mode you are
using.
2. Enter the desired
channel or frequency
step using the numeric
keypad.
3. [Enter] Notice (and verify) that the number you entered
(the channel step number or the frequency step
number) appears below the Chan Step or Freq Step
text on the corresponding button.