Technical data

202 Chapter 7
CDMA Analyzer
Optional CDMA Tx Analyzer Measurement Settings
CDMA Analyzer
Setting the Measurement Time Offset Limits
4 Set the upper limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [GHz], [MHz],
[kHz], or [Hz]
5 Set the lower limit.
a. [Low Limit]
b. Enter the number on
the numeric keypad.
c. [GHz], [MHz],
[kHz], or [Hz]
Step Notes
1 On [Time Offset Limits]
select
On or Off.
Enables you to toggle the measurement limits
function On (active) and Off (inactive).
• If set to
On, the displayed time offset metrics
will change from blue to red (fail) or green
(pass) and indicate either a “P” (pass) or “F”
(fail). If the measured values exceed the upper
or lower limit, the words ‘ALL PASS’, in the
bar at the bottom of the screen, will change to
‘FAILURE’.
• If set to
Off, the time offset value will be
displayed in blue. The bar at the bottom of the
screen will indicate measurement in progress.
Step Notes