Technical data

206 Chapter 7
CDMA Analyzer
Optional CDMA Tx Analyzer Measurement Settings
CDMA Analyzer
Setting the Measurement Pilot Power Limits
Step Notes
1 On [Pilot Power Limits]
select
On or Off.
Enables you to toggle the measurement limits
function On (active) and Off (inactive).
• If set to
On, the delta pilot power metrics will
change from blue to red (fail) or green (pass)
and indicate either a “P” (pass) or “F” (fail). If
the measured value exceeds the upper limit or
lower limit, ALL PASS, in the bar at the bottom
of the screen, will change to FAILURE.
• If set to
Off, the time pilot power value will be
displayed in blue. If NO limits are set to On, the
pass/fail bar will not be displayed at the bottom
of the screen.
2 Set the upper limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [dBm]
Delta Limit range: –150 to 100 dBm
3 Set the lower limit.
a. [Low Limit]
b. Enter the number on
the numeric keypad.
c. [dBm]
Delta Limit range: –150 to 100 dBm