Technical data

Chapter 8 231
CDMA Over Air
Optional CDMA Over Air Measurement Settings
CDMA Over Air
Optional CDMA Over Air Measurement Settings
You can alter several optional measurement parameters in CDMA Over Air:
“Setting the Channel or Frequency Step” on page 231
“Setting the PN Increment” on page 232
“Setting the Transmitter Reference Level” on page 232
“Setting the Active Channel Threshold Level and Auto Threshold Level” on
page 234
“Resetting Amplifier Capacity and Traffic Metrics” on page 235
“Setting Measurement Time” on page 235
“Setting Quick Page Channel” on page 236
“Setting Average, Sweep, and Restart” on page 237
“Adding a Marker” on page 238
“Setting the Pass/Fail Limits” on page 240
“Metrics Provided by CDMA Over Air Measurements” on page 252
“Interpretation of CDMA Over Air Measurement Results” on page 256
Setting the Channel or Frequency Step
You can set the channel or frequency step so you can quickly increment to the next
channel or frequency using the Up Arrow and Down Arrow buttons.
Step Notes
1 [Chan Step] or [Freq Step] This choice depends on the [Units] mode you
are using.
2 Enter the desired channel or
frequency step using the
numeric keypad.
3 [Enter] Notice (and verify) the number you entered
below the Chan Step or Freq Step text on the
corresponding button.