Technical data

Chapter 8 243
CDMA Over Air
Optional CDMA Over Air Measurement Settings
CDMA Over Air
Setting the Measurement Estimated Rho Lower Limit
2 Set the upper limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [μsec]
3 Set the lower limit.
a. [Low Limit]
b. Enter the number on
the numeric keypad.
c. [μsec]
Step Notes
1 On [Est. Rho Limit]
select
On or Off.
Enables you to toggle the measurements lower limit
function On (active) and Off (inactive).
• If set to
On, the displayed estimated Rho
metrics will change from blue to red (fail) or
green (pass) and indicate either a “P” (pass) or
“F” (fail). If the measured values exceed lower
limit, ALL PASS, in the bar at the bottom of the
screen, will change to FAILURE.
• If set to
Off, the time estimated Rho value will
be displayed in blue. The bar at the bottom of
the screen will indicate measurement in
progress.
Step Notes