Technical data

Chapter 9 269
Channel Scanner
Using the Channel Scanner
Channel Scanner
Entering the Channel Power Measurement Bandwidth and Time
When performing a channel power measurement, you must specify a measurement
bandwidth and measurement time. These parameters determine how the analyzer
measures each channel on the Channel Scanner. Depending on the modulation
format of signal you are trying to measure (CDMA, GSM, and so forth), different
measurement bandwidths and times are required. You have three ways of selecting
these parameters:
• Press [Format/BW], then on [Format Type] select
List, and then select the
format from a list—independently of the channel standard.
• Select [Format/BW], then on [Format Type] select
Cust. Then select the
measurement bandwidth and measurement time for each channel.
To Select the Channel Format Type:
6 Enter channels into the list.
a. Use [Insert Row] to add a channel,
then enter its number using the
numeric keypad and [Fwd] or [Rev]
to complete each entry.
b. Use [Delete Row] to remove
channels you do not want displayed.
Select a channel you want to
remove using the up and down
arrow buttons. Then press [Delete
Row] to remove the selected
channel.
c. [Ok]
Step Notes
1. [Format/BW]
Step Notes