Technical data

277
Distance to Fault
10 Distance to Fault
“Measuring Distance to Fault” on page 278
“Measured Distance - the Effects of Frequency and Points” on page 278
“Resolution - the Effects of Frequency and Points” on page 279
“Automatic and Manual Distance to Fault Measurements” on page 279
“Calibration - Minimizing your Workload” on page 281
“Performing a Basic Distance to Fault Measurement (Manual Frequency
Range)” on page 283
“Performing a Basic Distance to Fault Measurement (Automatic Frequency
Range)” on page 286
“Clearing Calibration” on page 290
“Displaying Location Information Using GPS” on page 291
“Viewing a Single Distance to Fault Sweep” on page 292
“Displaying the Top Four Faults” on page 292
“Setting Interference Rejection for a Distance to Fault Measurement” on
page 293
“Setting Average, Sweep, and Restart” on page 294
“Adding a Marker” on page 296
“Setting the Pass/Fail Limits” on page 297