Technical data

Chapter 10 283
Distance to Fault
Measuring Distance to Fault
Distance to Fault
Performing a Basic Distance to Fault Measurement
(Manual Frequency Range)
Step Notes
1
Mode
2 [Antenna/Cable]
3 [Distance to Fault] The distance to fault measurement takes a few
seconds to load.
4 On [Freq Range] select
Manual.
Each time you press this softkey, the selected
option changes.
5 [Start Freq]
6 Enter the start
frequency using the
numeric keypad.
7 [Hz], [kHz], [MHz], or
[GHz]
8 [Stop Freq]
9 Enter the stop
frequency using the
numeric keypad.
10 [Hz], [kHz], [MHz], or
[GHz]
11 On [Units] select
Meters or Feet.
Each time you press this softkey, the selected
option changes.
12 [Start Distance]