Technical data

286 Chapter 10
Distance to Fault
Measuring Distance to Fault
Distance to Fault
Performing a Basic Distance to Fault Measurement
(Automatic Frequency Range)
22 If your analyzer is
uncalibrated, or has
been calibrated over an
unsuitable frequency or
with the incorrect cable
type, press [Freq/Dist/
Calibrate]
23 [Calibrate] Follow the Calibration Wizard.
24 Connect the antenna
feedline and antenna.
Connect the antenna feedline to the RF Out/SWR
port.
25 (Recommended)
[Level] [Autoscale]
If you prefer to set the reference level manually,
after pressing [Level], press [Ref Level]. Then
enter the value you want using the numeric keypad
and press [dB].
Step Notes
1
Mode
Step Notes