Technical data

Chapter 12 331
GSM and EDGE Analyzer
Using the GSM Analyzer and the EDGE Analyzer
GSM and EDGE Analyzer
To Make a GSM or EDGE Tx Analyzer Measurement:
Step Notes
1 Mode
2 [Tx Analyzer] or [Over Air] Regardless of whether you select
[Tx Analyzer] or [Over Air] at this stage, you
will access the same measurement software in
the analyzer. This means you can select
[Tx Analyzer] and proceed to make an Over
the Air measurement, and you can select [Over
Air] and proceed to make a Tx Measurement.
The two options here are presented for your
convenience only, and have no further effect.
3 [GSM Analyzer] or [GSM
(w/ EDGE) Analyzer],
or
[GSM Over Air] or [GSM
(w/ EDGE) Over Air]
The wording on the key label is dependent on
whether or not you have Option 235 - EDGE
Analyzer installed, and also whether you
selected [Tx Analyzer] or [Over Air] at Step 2.
4[Chan Std]
5 Highlight the channel
standard you want using the
up and down arrow buttons.
Select a valid GSM standard such as
GSM-850 or EGSM-900. Notice that some
valid standards may not be visible to you until
you scroll down the screen.
6 [Select]
7 On [Scan Mode] select
Range, Auto, or List.
a. If you selected
Range or
Auto, go to step 8.
b. If you selected
List, go to
step 9.
Each time you press this menu key, the
selected option changes.