Technical data

Chapter 12 333
GSM and EDGE Analyzer
Using the GSM Analyzer and the EDGE Analyzer
GSM and EDGE Analyzer
11 On [Position], specify the
frequency or the channel
(depending on your units of
measurement - see Step 8) at
which you wish to make your
measurement.
The position you specify (specified either by
frequency or by channel number) is the
position at which your measurement will be
made. The numeric results that are displayed
refer to this frequency or channel only.
This position is indicated graphically on the
Channel Scanner view (see Step 13) by a
vertical yellow line.
12 Press [View].
13 Select the measurement view
you want shown by pressing
one of the three buttons listed
below:
a. [Channel Scanner]
b. [Power vs. Time]
c. [Spectrum]
You can select any one of the three graphical
views. The numeric results shown in the lower
portion of the screen are independent of the
graphical view you select. Changing your
graphical view does not change which
numeric results are displayed.
The numeric results are always taken from the
Position (frequency or channel) that you
specified at Step 11, and from the first slot at
that Position, that is, from Slot 0. This applies
even when you are not actually displaying
Slot 0 on the screen.
14 Connect to the base station or
to your antenna.
If you are making a transmitter measurement,
connect your analyzer to the base station. If
you are making an Over the Air measurement,
connect your analyzer to its antenna.
Step Notes