Technical data

Chapter 12 339
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement
Settings
You can change several optional measurement parameters in the GSM/EDGE Tx
Analyzer:
• “Setting your Scan Mode” on page 340
• “Adding or Deleting a List Item” on page 342
• “Setting the Start Frequency/Channel” on page 343
• “Setting the Frequency or Channel Step Size” on page 344
• “Setting the Stop Frequency/Channel” on page 345
• “Setting the Channel Standard” on page 346
• “Setting the Units of Measure for the Graphical Display” on page 346
• “Setting Autoscale” on page 347
• “Setting the Reference Level” on page 348
• “Setting Scale/Division” on page 348
• “Using GPS for Frequency Reference and Location Information” on page 348
• “Setting the Display Position” on page 349
• “Setting Auto Order” on page 350
• “Setting Bar Top and Units” on page 350
• “Setting Mid-Bar” on page 351
• “Setting Zoom” on page 351
• “Setting Zoom Offset” on page 352
• “Setting Zoom Interval” on page 353
• “Setting PvT Mask” on page 354
• “Setting Auto Mode Bar Count” on page 354
• “Setting Slot Synchronization” on page 355
• “Setting TS# (w/ BCCH)” on page 356
• “Setting the Pass/Fail Limits” on page 357