Technical data

342 Chapter 12
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
the displayed channels, but are only displayed for the single channel indicated
by the vertical yellow line, which can be adjusted by using the [Display],
[Position] menu keys. The maximum number of list items is 40. For further
details, see “Setting the Display Position” on page 349.
To Set the Scan Mode to List:
Adding or Deleting a List Item
You may add and delete list items from the Scan Mode List for the specific
channel/frequencies you want to measure.
NOTE If you duplicate a channel entry in your list, you might notice that the graphical
results for the duplicated channel vary. This is because the analyzer takes a separate
acquisition of data for each of the channel plots. The variance you see in the
displayed plots are due to the signal’s variance over time from one acquisition to the
next.
Step Notes
1 [Freq/Chan]
2 [Scan Mode] Each time you press this key, the selected
option changes. Set Scan Mode to List. For
further details on how to add or remove items
from your Scan List, see below.