Technical data

Chapter 12 345
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
To Set the Frequency or Channel Step Size:
Setting the Stop Frequency/Channel
• The Stop Frequency or Stop Channel sets the end frequency (or channel) to
which the analyzer will scan. You can specify either a Stop Frequency or a Stop
Channel, depending on your Units setting. This is described in “Setting the Units
of Measure for the Graphical Display” on page 346.
To Set the Stop Frequency or the Stop Channel:
Step Notes
1 [Step Size] This choice depends on the [Units] mode you are
using.
2 Enter the desired
channel or frequency
step using the numeric
keypad.
3[Up] or [Dn]
or
[Hz], [kHz], [MHz], or
[GHz]
This choice depends on the [Units] mode you are
using.
When specifying a frequency, terminate your
selection with one of the frequency units of
measure.
Notice (and verify) that the number you entered
appears below the Chan Step or Freq Step text on
the corresponding button.
Step Notes
1 [Stop Freq] or [Stop
Chan]
This choice depends on the [Units] mode you are
using.
2 Enter the desired
channel or frequency
step using the numeric
keypad.