Technical data

Chapter 12 349
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
Setting the Display Position
You can set the location or position of the channel of interest. This determines the
channel used to calculate the measurement metrics displayed in the metrics portion
of the display. It also determines the center frequency in Spectrum View, and the
channel from where slot information is displayed in the Power versus Time view.
In the Channel Scanner view only, the channel of interest is indicated by vertical
yellow line.
To Set the Display Position:
Step Notes
1 [Level/Location]
2 On [Show GPS
Location] select
On.
Displays GPS satellite location information. Uses the
internal GPS to capture the location at which a
measurement is made. The GPS information can be
used to return to the same location. The Time Ref
(Freq/Chan/Time Ref mode) button must be set to
Internal GPS for this function to be active.
Information logged includes longitude, latitude,
altitude (feet/meters), and the number of satellites
tracked.
Each time you press this menu key, the selected
option changes.
3 Highlight [On] Toggle to [On] to display GPS satellite location
information. Toggle to [Off] to remove the location
information.
Step Notes
1[Display]
2 [Position]