Technical data

Chapter 12 351
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
To Set Bar Top:
Setting Mid-Bar
You can set BSIC to be displayed at the middle of the channel bars.
This setting is only available when View is set to Channel Scanner, and when Scan
Mode is set to Auto or to List.
To Set Mid-Bar:
Setting Zoom
You can zoom into one or more of the eight slots in a channel, or you can zoom in
further to look at just the rising and falling edges of a single slot. You use this Zoom
setting to determine whether the analyzer displays the complete slot(s), or only the
rising and falling edges.
If you select Zoom Rise/Fall to look at the rising and falling edges of a single slot,
and your Zoom Interval is set to greater than one slot, the slot whose rising and
falling edges are displayed is the slot corresponding to your Zoom Offset setting.
This setting is only available when View is set to Power versus Time.
For details on setting the Zoom Interval, see “Setting Zoom Interval” on page 353.
For details on setting the Zoom Offset, see “Setting Zoom Offset” on page 352.
Step Notes
1[Display]
2 On [Bar Top] select
Off or
Pwr.
Each time you press this menu key, the
selected option changes.
2 On [Units] select
dBm or
Watts.
Each time you press this menu key, the
selected option changes.
Step Notes
1[Display]
2 On [Mid-Bar] select
Off or
BSIC.
Each time you press this menu key, the
selected option changes.