Technical data

354 Chapter 12
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
For details on setting the Zoom Offset, see “Setting Zoom Offset” on page 352.
For details on setting Zoom, see “Setting Zoom” on page 351.
To Set Zoom Interval:
Setting PvT Mask
You can choose to display or to hide the Power versus Time Mask using the PvT
Mask menu key.
The EDGE specifications set minimum and maximum limits to the slot power when
measured over time. The PvT mask displays these limits on the screen. The Lower
Limit Mask is shown in yellow, and the Upper Limit Mask is shown in magenta
(pink).
This setting is only available when View is set to Power versus Time.
To Set the PvT Mask:
Setting Auto Mode Bar Count
The Measurement Bar Count setting allows you to alter the number of channel data
bars displayed when you set the [Scan Mode] to
Auto. The channels that have the
highest power will be displayed, up to the number of channels you have set.
If you set you Start Freq mode to Chan, your E7495 test set displays only one
channel, so your Auto Mode Bar Count is automatically set to 1. If you later set your
Step Notes
1[Display]
2 [Zoom Interval] Enter the number of slots using the numeric
keypad, and terminate your selection using the
[Slots] menu key. You can also use the knob or
the up and down arrow keys to set the Zoom
Interval.
Step Notes
1[Display]
2 On [PvT Mask], select
On or
Off.
Each time you press this menu key, the
selected option changes.