Technical data

356 Chapter 12
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
(Training Sequence number) if a BCCH (Broadcasting Control Channel) is
detected. If Option 235 - EDGE Analyzer is not installed, only GMSK signals
can be demodulated. For more details on TS#, refer to “Setting TS# (w/ BCCH)”
on page 356.
If no BCCH is detected,
Auto is used even though Specified TS# (w/ BCCH) is
still selected.
If you have Slot Sync set to
Specified TS# (w/ BCCH), and no BCCH channel is
found, the message “BCCH not found - using Auto Slot Sync” will be displayed.
To Set the Slot Synchronization:
Setting TS# (w/ BCCH)
The TS# (w/ BCCH) setting allows you to specify which Training Sequence is used
for slot synchronization. This parameter is disabled unless Slot Sync is set to
Specified TS# (w/ BCCH). For more details on setting Slot Sync, refer to “Setting
Slot Synchronization” on page 355.
To Set the Training Sequence Number:
Step Notes
1 [Setup]
2 [Slot Sync]
3 [Highest Pwr], [Auto],
[GMSK], [8PSK], or
[Specified TS#
(w/ BCCH)]
[GMSK] and [8PSK] are only available if you have
Option 235 - EDGE Analyzer installed.
Step Notes
1 [Setup]
2 [Specified TS#
(w/ BCCH)]
This key is disabled unless Slot Sync is set to
Specified TS# (w/ BCCH)
3 Enter the TS# using the
numeric keypad.
You must enter a number between 0 and 7.
4[Enter]