Technical data

358 Chapter 12

GSM and EDGE Analyzer

Optional GSM and EDGE Tx Analyzer Measurement Settings

GSM and EDGE Analyzer

To Set the Channel Scan Upper and Lower Limits:

Setting Frequency Error Limits

You can set upper and lower Frequency Error Limits for your Frequency Error

Measurement results.

If Freq Error Limits are turned On, and your measured frequency error is within the

limits you have specified, the numeric result reported in the metrics portion of the

screen will be displayed in green, and the Limit Pass will be indicated by “(P)” after

the result. If your measured frequency error is outside your specified limits, the

numeric result reported in the metrics portion of the screen will be displayed in red,

and the Limit Failure will be indicated by “(F)” after the result.

To Set the Frequency Error Upper and Lower Limits:

Step Notes

1 [Setup]

2 [Chan Scan Pwr Limits]

3 [Limits]

4 [On] or [Off]

5 Set the upper limit.

a. [High Limit]

b. Enter the number on

the numeric keypad.

c. [dBm]

The limit is specified in dBm.