Technical data

Chapter 12 361
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
To Set the I/Q Offset Limit:
Setting the RMS Phase Error Limit
You can set an upper RMS Phase Error Limit for your Measurement results.
If RMS Ph Err Limit is turned On, and your measured RMS Phase Error is below
the limit you have specified, the numeric results reported in the metrics portion of
the screen will be displayed in green, and the Limit Pass will be indicated by “(P)”
after the result. If your measured RMS Phase Error is above your specified limit, the
numeric result reported in the metrics portion of the screen will be displayed in red,
and the Limit Failure will be indicated by “(F)” after the results.
To Set the RMS Phase Error Limit:
Step Notes
1[Setup]
2 [I/Q Offset Limits]
3 [Limits]
4 [On] or [Off]
5 Set the high limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [dB]
Step Notes
1[Setup]
2 [RMS Ph Err Limits]
3 [Limits]
4 [On] or [Off]