Technical data

362 Chapter 12

GSM and EDGE Analyzer

Optional GSM and EDGE Tx Analyzer Measurement Settings

GSM and EDGE Analyzer

Setting the Peak Phase Error Limit

You can set an upper Peak Phase Error Limit for your Measurement results.

If Peak Ph Err Limit is turned On, and your measured Peak Phase Error is below the

limit you have specified, the numeric results reported in the metrics portion of the

screen will be displayed in green, and the Limit Pass will be indicated by “(P)” after

the result. If your measured Peak Phase Error is above your specified limit, the

numeric result reported in the metrics portion of the screen will be displayed in red,

and the Limit Failure will be indicated by “(F)” after the results.

To Set the Peak Phase Error Limit:

Setting the RMS EVM Limit

You can set an upper RMS Error Vector Magnitude Limit for your Measurement

5 Set the high limit.

a. [High Limit]

b. Enter the number on

the numeric keypad.

c. [deg]

Step Notes

1 [Setup]

2 [Peak Ph Err Limits]