Technical data

Chapter 12 363
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
GSM and EDGE Analyzer
results.
If RMS EVM Limit is turned On, and your measured RMS EVM is below the limit
you have specified, the numeric results reported in the metrics portion of the screen
will be displayed in green, and the Limit Pass will be indicated by “(P)” after the
result. If your measured RMS EVM is above your specified limit, the numeric result
reported in the metrics portion of the screen will be displayed in red, and the Limit
Failure will be indicated by “(F)” after the results.
To Set the RMS EVM Limit:
Setting the Peak EVM Limit
You can set an upper Peak Error Vector Magnitude Limit for your Measurement
results.
If Peak EVM Limit is turned On, and your measured Peak EVM is below the limit
you have specified, the numeric results reported in the metrics portion of the screen
will be displayed in green, and the Limit Pass will be indicated by “(P)” after the
result. If your measured Peak EVM is above your specified limit, the numeric result
reported in the metrics portion of the screen will be displayed in red, and the Limit
Failure will be indicated by “(F)” after the results.
To Set the Peak Phase Error Limit:
Step Notes
1[Setup]
2 [RMS EVM Limits]
3 [Limits]
4 [On] or [Off]
5 Set the high limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [%]
Step Notes
1[Setup]