Technical data

406 Chapter 15
Signal Generator
Using the Signal Generator
Signal Generator
10 [Select]
11 [Channel]
12 Enter the channel number
using the numeric keypad.
When the channel is set, it is set across all the
test set tools, so as you switch between tools,
the channel is preset.
13 [Rev] or [Up] Always choose the reverse or the uplink
channel when performing a receiver
sensitivity test measurement.The terms
“Reverse link” and “Uplink” have the same
meaning. GSM standards use the term “Up”
whereas cdma standards use the term
“Reverse”.
14 [Modulation]
If the key is grayed out, go to
step 16.
Or
If the key is active, go to the
next step.
If the [Modulation] menu key is grayed out,
your test set does not include the Option
510 - CW & Complex Modulation Signal
Generator. You have only CW source.
Step Notes