Technical data

420 Chapter 16

Spectrum Analyzer

Using the Spectrum Analyzer

Spectrum Analyzer

NOTE The Sensitivity setting is coupled to the Noise Correction setting. Changing the

Sensitivity setting from

Low to High will cause the Noise Correction setting to

change from

On to Off. Conversely, if the Noise Correction setting is changed from

Off to On, the Sensitivity setting is changed from High to Low.

Setting the Analyzer Detector

You can set a detector mode for spectrum measurements.

Positive peak detection displays the highest sample level measured during each

sampling period.

Sample detection displays the peak of CW-like signals and maximums and

minimums of noise-like signals.

Negative peak detection displays the lowest sample level measured during each

sampling period.

Average detection displays the average power in each frequency measured

across the spectrum.

2. [Sensitivity]

Low or High

Step Notes

1. [Setup]

2. [Detector]

3. [Peak], [Sample], [Negative Peak],

or [Average]