Technical data

Chapter 16 431
Spectrum Analyzer
Using the Spectrum Analyzer
Spectrum Analyzer
7 • If you only need an
upper limit line, stop
here.
• If you need a lower
limit line:
a. On [Limits]
select
Lower
b. Repeat steps 4, 5,
and 6.
• For a segmented
limit line, proceed
with step 8.
8 Set the first segment
limit.
a. On [Segments] select
1st
9
On [1
st
Segment] select
On or Off.
Enables you to toggle the measurement limit line
segment function
On (active) and Off (inactive).
• If set to
On, a left and right upper limit line
segment with a pass or fail icon above each
segment is displayed on the screen. This
enables you to set the first segment left and
right limit values and the width of the left and
right first segment. (The first segment width
(Span) is unavailable unless the second
segment is turned on.) Any measured value that
exceeds the upper limit will result in a failure
indication.
• If set to
Off, neither limit lines nor pass fail
indicators are displayed. Nor are second
segment functions available.
Step Notes