Technical data

432 Chapter 16
Spectrum Analyzer
Using the Spectrum Analyzer
Spectrum Analyzer
10 Set the first segment left
and right limit values.
a. On [1
st
Segment]
select
Left.
b. [Level]
c. Enter the number on
the numeric keypad.
d. [dB]
e. On [1
st
Segment]
select
Right.
f. Repeat steps b, c, and
d.
Maximum Upper limit: 50 dBm to –150 dBm (if a
lower limit is set, the upper limit should be set
higher than the lower limit)
11 Set the center segment
width value.
a. On [Segments] select
Center
b. [Center Span]
c. Enter the number on
the numeric keypad.
d. [GHz], [MHz],
[kHz], or [Hz]
12 • If you only need a
two segment limit
line, stop here.
• For a three segment
limit line, proceed
with step 13.
13 On [Segments] select
2nd
Step Notes