Technical data

Chapter 17 475
Basic System Operations
Configuring for Network Connectivity
Basic System Operations
Configuring for Network Connectivity
The E7495A/B can operate as a device on any compatible network. In order to be
accessible on the network, certain information must be entered so the test set can
communicate with other devices. Configuring the test set for network activity is
performed by using the IP administrator located in the system utilities.
IP Administration Using DHCP
Perform this procedure to allow your test set to be integrated into an existing
network that uses DHCP to dynamically assign an IP address. This procedure
requires that you have the System Name (available from your network
administrator).
IP Administration Without DHCP
Perform this procedure to allow your test set to be integrated into an existing
network that uses a technique other than DHCP for its IP address assignments. One
Step Notes
1[System]
2[Controls]
3[IP Admin]
4[Sys Name]
5 Enter the name of the
test set.
This is automatically assigned by the network
administrator.
6[Ok]
7 On [DHCP] select
On.
An IP address and other network information will
automatically be assigned if the Sys Name is
recognized by the network.
8 [Save]
9 [Ok] Saves the current configuration and restarts the test
set. DHCP will dynamically assign an IP address.