Technical data

494 Chapter 18
T1 Analyzer
Making T1 Measurements
T1 Analyzer
Figure 18-1 Sample End to End Connection Diagram
To Preform a Hard Loop/End-End Full T1 BERT Test
Step Notes
1 Connect the BSTS to the
DSX panel
Refer to Figure 18-1
2 [Mode]
3 [Backhaul]
4 [T1 Analyzer]
5 Select a test mode.
a. [Get Started/ Test Mode]
b. [Hard Loop/End-End]
c. [Full T1 BERT]
Use this test mode to perform measurements
such as BERT on a T1 circuit. The far end
signal must be derived from either a hard loop
or from a second test set. The T1 circuit is not
available for service when using this test mode.
Select this to perform a BERT test on a full T1
Circuit.