Technical data

502 Chapter 18
T1 Analyzer
Making T1 Measurements
T1 Analyzer
18 Setup the results display.
a. [Results]
b. Use the up and down
arrows to select.
c. Make a selection.
d. [Select]
Enables a list of results information that can be
displayed in the Results pane. Make a
selection based on the need of the application.
19 Setup the controls and select
a pattern.
a. [Control]
b. [Pattern]
c. Use the up and down
buttons to select.
d. QRSS
e. [Select]
20 Select the alarm.
a. [Alarm/Error]
b. Use the up and down
buttons to select.
c. Loss of Signal
d. [Select]
21 [Send Loop Up] Sends a loop up command to the far end and
reports the loop state on the status line. If a
pre-existing loop is detected at the far end then
“Pre-existing loop” is displayed on the status
line. This is only possible in In-band mode.
22 [Send Loop Down] Sends a loop down command to the far end and
reports the loop state on the status line.
Step Notes