Technical data

504 Chapter 18
T1 Analyzer
Making T1 Measurements
T1 Analyzer
When using the above sample connection for monitoring a T1 circuit with a monitor
port, you should set Rx Input to monitor.
Figure 18-4 Sample Monitor Mode Without a Monitor Port Connection
When using the above sample connection for terminating an T1 circuit, set Rx Input
to terminate.
To Preform a Monitor Full T1 BERT Test
Step Notes
1 Connect the BSTS to
the DSX panel
For a DSX with a monitor port connection, refer to
Figure 18-3
For a DSX without a monitor port connection,
refer to Figure 18-4
2 [Mode]
3 [Backhaul]
4 [T1 Analyzer]
5[Get Started/ Test
Mode]