Technical data

Chapter 18 511
T1 Analyzer
Making T1 Measurements
T1 Analyzer
10 Select a pattern.
a. [Pattern]
b. Use the up and down
buttons to select.
c. QRSS
d. [Select]
11 Setup Tx LBO.
a. [Tx LBO]
b. [0 dB]
This is a typical level found at the customer
demarcation point.
12 [More 1 of 2] Displays the rest of the Setup options.
13 Setup the loop code.
a. [Loop Code]
b. [ESF Data Link]
Configures what type of loop code this test
set will respond to. Requires a Datalink loop
code for this test set to enter loopback mode.
14 [Display] Enables the Display options on the buttons
on the right.
15 Setup the results display.
a. [Results]
b. Use the up and down
arrows to select.
c. Make a selection.
d. [Select]
Enables a list of results information that can
be displayed in the Results pane. Make a
selection based on the need of the
application.
16 [Control] The selection enables several soft keys on the
right that control choices specific to each test
mode.
17 [Pattern] Select a pattern.
18 [Self Loop Up] Forces the test set to enter loop-up state.
19 [Self Loop Down] Forces the test set to enter loop-down state.
Step Notes