Technical data

56 Chapter 2
One Port Insertion Loss
Measuring One Port Insertion Loss
One Port Insertion Loss
Setting One Port Insertion Loss Interference Rejection
Other signals can interfere with One Port Insertion Loss measurements. When
making a one port insertion loss measurement in the presence of known or suspected
interference, you can minimize the effect of the interference on the measurement by
activating interference rejection in the test set.
NOTE Use of interference rejection will increase the measurement time. Interference
rejection should be used if a known interfering signal exists or if the one port
insertion loss measurement displays suspicious characteristics such as a spike or
rapid movements in the noise floor.
To activate interference rejection:
Step Notes
1[Setup]
2 On [Interference
Rejection] select On.
Each time you press this softkey, the selected option
changes.