Technical data

592 Chapter 20
W-CDMA or W-CDMA (with HSDPA) Over Air
Using the W-CDMA or W-CDMA (with HSDPA) Over the Air Tool
W-CDMA or W-CDMA (with HSDPA)
Over Air
NOTE The key labelled “Update Interval” was labelled “Capture Interval” in earlier
versions of the software (A.04.00 or earlier). The way the key works has not
changed. Only the key label has changed to clarify its function.
4 [Reset Codogram] This restarts the data capture for the
Codogram. You may see the screen
freeze for a few seconds before the
display starts plotting data again.
5 If desired set the update interval:
a. [Update Interval]
b. Enter the interval number of
seconds using the numeric
keypad.
c. Select [sec] or [Max Speed].
Allows you to set the update interval to 0,
1, or more seconds. Alternatively, you
may set it to automatically determine the
update interval that provides the
maximum data collection speed.
If you need to return to the automatically
determined maximum display update
rate, you must press [Update Interval]
followed by a numeric keypad key to
access [Max Speed].
6 If desired set the display color:
a. [Palette]
b. Select [Full Color] or
[Grayscale].
The color/grayscale top and bottom
mappings are determined by the Ref
Level and Scale/Div settings. To change
the mapping, go to [Level/Location] and
change [Ref Level] and [Scale/Div].
Step Notes